Audio Research Reference 750 SEL
The Reference 750 SEL monoblock amplifier continues the story begun 25 years ago with the introduction of the Reference 600; that is, to create the ultimate, vacuum-tube amplifier with enough power to drive any speaker, and to provide a musical experience unlike any before it.
Mono block amplifier. Priced per single block.
The Reference 750 SEL monoblock amplifier continues the story begun 25 years ago with the introduction of the Reference 600; that is, to create the ultimate, vacuum-tube amplifier with enough power to drive any speaker, and to provide a musical experience unlike any before it.
Mono block amplifier. Priced per single block.
The Reference 750 SEL monoblock amplifier continues the story begun 25 years ago with the introduction of the Reference 600; that is, to create the ultimate, vacuum-tube amplifier with enough power to drive any speaker, and to provide a musical experience unlike any before it.
Mono block amplifier. Priced per single block.
PRODUCT DETAILS
Technical Specifications
POWER OUTPUT- 750 watts per channel continuous from 20Hz to 20kHz. 1kHz total harmonic distortion typically 0.5% at 750 watts, below .04% at 1 watt. Approximate actual power available at “clipping” 850 watts (1kHz). (Note that actual power output is dependent upon both line voltage and “condition” i.e. if the power line has high distortion, maximum power will be affected adversely, although from a listening standpoint this is not very critical.)
POWER BANDWIDTH- (-3dB points) 15Hz to 150kHz.
FREQUENCY RESPONSE- (-3dB points at 1 watt) 1 Hz to 200 kHz.
INPUT SENSITIVITY- 4.6V RMS Balanced for rated output. (24 dB gain into 8 ohms.)
INPUT IMPEDANCE- 200K ohms Balanced.
OUTPUT TAPS- 4, 8, 16 ohms.
OUTPUT REGULATION- Approximately 0.5dB 16-ohm load to open circuit (Damping factor approximately 17).
OVERALL NEGATIVE FEEDBACK- 13dB.
SLEW RATE- 20 volts/microsecond.
RISE TIME- 1.5 microseconds.
HUM & NOISE- Less than 0.2mV RMS – 110dB below rated output (IHF-A-weighted, input shorted, 16-ohm output).
Physical Specifications
POWER SUPPLY ENERGY STORAGE- Approximately 1300 joules.
POWER REQUIREMENTS- 105-130VAC 60Hz (200-270VAC 50Hz) 2100 watts at rated output, 2400 watts maximum, 800 watts at “idle”.
TUBES REQUIRED- 8 Matched pair KT150 Power Output; 1 6550WE Regulator; 1 6H30 Regulator Amplifier; 1 matched pair KT150 Driver; 1 6H30 follower.
DIMENSIONS-
13.5″ (34.3 cm) W x 23″ (58.4 cm) H x 20.8″ (52.8 cm) D.
Handles extend 1.5″ (3.8 cm) forward and rearward.
WEIGHT- 170 lbs. (77.2 kg) Net; 395 lbs. (180 kg) per pair shipped weight.
